multiple destination on Junction Turnout
Verfasst: Freitag 12. Februar 2016, 11:04
Hallo all,
I can't seem to figure this one out, so I hope some of you might have the answer..
The new(ish) destinations option add great functionality and ease to setting up routes and shunting. However I am running into a problem: I would like to use destinations on my junction turnouts to guide trains to a specific platform in my stations. So certain trains would get destinations like "Platform01", "Platform02", "Platform03" etc.
The advantage of this is that I never have to change my routes through the stations but only have to give a train a destination at the start of the station throat, then get it's next destination on the actual platform and leave the station to its next destination..
Before I would use Junction Turnouts for this, but it meant that every time I planned in a new route I had to change all the points from point of origin to the arrival platform, if I can make it work with destinations I would only need to change one Data Changing Point..
But here is the problem: As far as I can see the Junction Turnouts do not allow you to use multiple destinations, at least not for 'all routes' (i.e *(d="Platform01","Platform02") or *(d="Platform01,Platform02") or *(d="Platform01"|"Platform02") or *(d="Platform01",d="Platform02" aren't allowed...).
I've tried any combination I could think of but Bahn is either asking me to register a new destination ("Platform01,Platform02") or simple won't allow it.
This anybody find a solution for this problem or is this simply not possible??
I can't seem to figure this one out, so I hope some of you might have the answer..
The new(ish) destinations option add great functionality and ease to setting up routes and shunting. However I am running into a problem: I would like to use destinations on my junction turnouts to guide trains to a specific platform in my stations. So certain trains would get destinations like "Platform01", "Platform02", "Platform03" etc.
The advantage of this is that I never have to change my routes through the stations but only have to give a train a destination at the start of the station throat, then get it's next destination on the actual platform and leave the station to its next destination..
Before I would use Junction Turnouts for this, but it meant that every time I planned in a new route I had to change all the points from point of origin to the arrival platform, if I can make it work with destinations I would only need to change one Data Changing Point..
But here is the problem: As far as I can see the Junction Turnouts do not allow you to use multiple destinations, at least not for 'all routes' (i.e *(d="Platform01","Platform02") or *(d="Platform01,Platform02") or *(d="Platform01"|"Platform02") or *(d="Platform01",d="Platform02" aren't allowed...).
I've tried any combination I could think of but Bahn is either asking me to register a new destination ("Platform01,Platform02") or simple won't allow it.
This anybody find a solution for this problem or is this simply not possible??